VooPoo presents the VooPoo Drag 2 177W TC Starter Kit, a combination of the Drag 2 177W Gene.FIT Chip Box Mod and the redesigned UFORCE T2 Sub-Ohm Tank. The upgraded Gene.FIT chip is secured by a V0 class fireproofing bridge to block liquid, dust, or burnout. The new chip has an increased 5 to 177W power output, 0.05 to 5.0 ohm resistance, 0 to 7.5V output, and 40A max current output. VooPoo has retained the magnetic battery access door that houses two 18650 batteries (sold separately) as well as the three button control scheme with an enlarged firing button and two adjustment buttons. Drag 2 box mod has a 0.91 Inch OLED display that shows temperature mode and output, output power, atomizer resistance, and battery life indicator. The body of the Drag 2 is 25% smaller than the previous design but retains the beautiful zinc alloy frame, DRAG lettering on the fixed panel, and a gorgeous resin magnetic battery panel. On top of the device is a spring loaded gold plated 510 connection with a stainless steel thread point. This box mod also comes with a host of protections such as battery reverse protection, over charge protection, and balanced battery charging. The VooPoo Drag 2 has been paired with the redesgined UForce 24.6mm Sub-Ohm Tank that has a 8ml bubble glass e-liquid capacity and 3.5ml capacity with the standard glass tank. This sub-ohm tank's top fill port can be accessed through a slide-to-fill top cap. The UForce T2 Sub-Ohm Tank is compatible with the entire UForce replacement coil family and comes with the U2 and N2 replacement coils. The UForce U2 is a dual kanthal coil with an atomizer resistance of 0.4 ohm, recommended range of 40 to 80W, and is best at 55 to 65W. The new UForce N2 coils are dual kanthal mesh, have a resistance of 0.3 ohm, a recommended range of 45 to 80W, and is best at 55 to 65W. The UForce T2 has three fully adjustable 10mm by 3mm air slots. The UForce T2 has a stainless steel 510 threading, 24K gold plated contact and a 14mm wide 810 bore drip tip.